Characterization of Fabricated Photonic Crystal Fibers Using Effective Index Method

Seraji, Faramarz

doi:10.1234/mjee.v3i3.70

Document Type : Review Article

Author

Faramarz Seraji

ITRC

https://doi.org/10.1234/mjee.v3i3.70

Abstract

In this paper, the characteristics of photonic crystal fibers (PCFs), which have been experimentally determined in the last few years in Iran's Telecom Research Center are analyzed and compared theoretically using an effective index method. The PCFs under investigation are fabricated with a high speed drawing process that has not yet been reported elsewhere. It was shown that at higher wavelengths in PCFs; the light field is confined in the core where in shorter wavelengths the field spreads into the cladding region. This phenomenon leads to affect the numerical aperture and the normalized frequency of the PCFs, because these two parameters directly depend on the diameter of the air-hole and the spacing between them in the cladding region. The measured results show that the PCF fabricated at high drawing speeds has a loss of 12 dB/km of speed, which is a reasonable level compared to other published reports. In addition, we have shown that a lower spacing between the adjacent air-holes would reduce the loss in the PCFs.

Keywords

References

[1] P. St. J. Russell, T. A. Birks, J. C. Knight, R. F. Cregan and J.-P. De Sandro, "Silica/air photonic crystal fibres", Jap. J. Appl. Phys, 37 Suppl. 37-1, pp. 45-48, 1998.

[2] J. C. Knight, T. A. Birks, P. St. J. Russell, and D. M. Atkin, "All-silica single-mode optical fiber with photonic crystal cladding", Opt. Lett., Vol 22, pp.1547-1549, 1996.

[3] T. M. Monro and D. J. Richardson, "Holey optical fibres: Fundamental properties and device applications", C. R. Physique, pp. 175–186, 2003.

[4] J. B. Eom, K. W. Park, T.–J. Eom, Y. Chung, W. T. Han, U. C. Paek, and B. H. Lee, "Transmission and numerical aperture measurement of photonic crystal fiber", OECC 2001, Post Deadline PDP2.05, 2001.

[5] Faramarz E. Seraji, A. R. Hassani, N. Granpayeh, M. S. Zabihi, A. R. Bahrampour, and H. Amiri, "Design and fabrication of holey fibres", Proc. 10th Photonics Conf. Iran, Kerman, pp. 64-66, 28-29 Jan., 2004.

[6] Faramarz E. Seraji, M. Rashidi, and Maryam Karimi "Characteristics of holey fibers fabricated at different drawing speeds", Chinese Opt. Lett., Vol. 5, Issue 3, pp. 131-134, 2007.

[7] Faramarz E. Seraji, M. Rashidi, and M. Karimi, "Analysis and comparison of attenuation of fabricated holey fibres by effective refractive index method", Proc. 11th Optics and Photonics Conf. Iran, Shahid Beheshti Univ., Tehran, 2, 3 Feb. 2005. pp. 276-280.

[8] Faramarz E. Seraji, Mahnaz Rashidi, and Vajieh Khasheie, "Parameter analysis of a photonic crystal fiber with raised-core index profile based on effective index method" Chinese Opt. Lett., Vol. 4, No. 8, pp. 442-445, 2006.

[9] J. Broeng, D. Mogilevstev, S. E. Barkou and A. Bjarklev, “A new class of optical waveguides", Optical Fiber Technol., Vol 5, pp. 305-330, 1999.

[10] T. M. Monro, D. J. Richardson, N. G. R. Broderick, and P. J. Bennett, “Holey optical fibers: An efficient modal model", IEEE J. Lightwave Technol‚ Vol. l7‚No. 6‚ pp.1093, 1999.

[11] S. K. Varshney and R. K. Sinha, “Characterization of photonic crystal fibers from far field measurements", J. Micro. Optoelectron., Vol. 2, No. 6, Dec. 2002.

[12] N. A. Mortensen, J. R. Folken, P. M. W. Skovgaard, J. Broeng, “Numerical aperture of single-mode photonic crystal fibers", IEEE Photonics Technol. Lett.,Vol. 14, No. 8, pp. 1094-1096, 2002.

[13] A. Ghatak and K. Thyagarajan, Introduction to Fiber Optics, Cambridge University Press, New Delhi, 2002.

[14] R. K. Sinha, M. P. Sing, S. K. Varshney, "Propagation characteristics of photonic crystal fibers" J. Optical Commu., Vol. 24, No.5, pp 192-198, 2003.

[15] M. Rashidi and Faramarz E. Seraji, "Measurement of numerical aperture and normalized frequency of photonic crystal fibers with analysis based on effective index method", Proc. 12th Optic and Photonics Conf. Iran, Shiraz Univ., Feb. 2006.

Majlesi Journal of Electrical Engineering

Characterization of Fabricated Photonic Crystal Fibers Using Effective Index Method

References

References

Volume 3, Issue 3 - Serial Number 3
March 2009
Pages 9-19

Characterization of Fabricated Photonic Crystal Fibers Using Effective Index Method

References

References

Volume 3, Issue 3 - Serial Number 3March 2009Pages 9-19

Volume 3, Issue 3 - Serial Number 3
March 2009
Pages 9-19