Reliability Indices Utlization in Combined Heat and Power ( CHP ) Optimal Operation

Hosseinnia, Hamed; Nazarpour, Dariush; Rezaei Benam, Masoud

Document Type : Review Article

Authors

¹ Department of Electrical Engineering, Urmia university, Urmia, Iran

² Department of Electrical Engineering, Sharif university, Tehran, Iran

Abstract

The reason that cogeneration is being used more compared to separate heat and power is because it is more efficient. In this paper the goal is finding the optimized CHP system utility size and thermal storage considering reliability limits of boiler and grid connected bus. Loss of Load Expectation (LOLE) and Expected energy not supplied (EENS) are considered as two reliability indices to insure the security of operation. non-sequentional Monte carlo simulation method is introduced to the reliability assessment of CHP,and a normal distribution electrical load model is built to simulate the hourly electrical load.CHP model combined with a two-state reliability model is applied to monte carlo simulation method, and results show that the CHP reliability model works well with non-sequential monte carlo simulation. Non-Sequential Monte Carlo method is used to generate scenarios. Also in order to reduce computation time and due to the large number of scenarios, a scenario reduction technique is used. GAMS software is used for optimization object.

Keywords

References

[1] P.J. Mago, L.M. Chamra, .Analysis and optimization of CCHP systems based on energy, economical, and environmental considerations. Energy and Buildings 41 (2009) 1099–1106.

[2] Zhang Beihong, Long Weiding, .An optimal sizing method for cogeneration plants. Energy and Buildings, 38 (2006) 189–195.

[3] Sompop Pattanariyankool, Lester B. Lave, “Optimizing transmission from distant wind farms”, Energy Policy, Vol. 38, Issue 6, pp. 2806-2815, June 2010.

[4] Jorge Valenzuela, Jianhui Wang, “A probabilistic model for assessing the long-term economics of wind energy”, Electric Power Systems Research 81 (2011) 853–861.

[5] M. Dicorato, G. Forte, M. Pisani and M. Trovato, “Guidelines for assessment of investment cost for offshore wind generation”, sciencedirect Renewable Energy, Vol. 36, Issue 8, pp. 2043-2051, August 2011.

[6] R. Billinton and A. Sankarakrishnan. A comparison of Monte Carlo simulation techniques for composite power system reliability assessment. in WESCANEX 95. Communications, Power, and Computing. Conference Proceedings, IEEE, 1995, pp. 145-150 vol.1

[7] F. Careri, C. Genesi, P.Marannino, M. Montagna, S. Rossi, “Wind power generation and transmission system planning: the Italian case”, MELECON 2010 - 2010 15th IEEE Mediterranean, pp. 979-984, April 2010.

[8] Heitsch, H.; Romisch, W. Scenario reduction algorithms in stochastic programming. Computational Optimization and Applications 24 (2003), 187-206.

[9] Integrating Large-Scale Photovoltaic Power Plants into the Grid, Peter Mark Jansson, Richard A. Michelfelder, Victor E. Udo, Gary Sheehan, Sarah Hetznecker, Michae Freeman, 2008.

[10] Ahmed R. Abul’Wafa, “Reliability/cost evaluation of a wind power delivery system”, sciencedirect Electric Power Systems Research, Vol. 81, Issue 4, pp. 873-879, April. 2011.

[11] Integrating Large-Scale Photovoltaic Power Plants into the Grid, Peter Mark Jansson, Richard A. Michelfelder, Victor E. Udo, Gary Sheehan, Sarah Hetznecker, Michae Freeman, 2008.

[12] M. Dicorato, G. Forte, M. Pisani and M. Trovato, “Guidelines for assessment of investment cost for offshore wind generation”, sciencedirect Renewable Energy, Vol. 36, Issue 8, pp. 2043-2051, August 2011

[13] L. Wu, M. Shahidehpour, and T. Li. Stochastic security-constrained unit commitment. IEEE Trans. Power Syst., vol. 22, no. 2, pp.800–811, May 2007IEEE Guide for Application of Power Apparatus Bushings, IEEE Standard C57.19.100-1995, Aug. 1995.

[14] Cheng-Chien Kuo, “Generation dispatch under large penetration of wind energy considering emission and economy”, Energy Conversion andManagement51 (2010)89–97.

[15] K.F. Schenk, S. Chan, “Incorporation and Impact of a Wind Energy Conversion System in Generation Expansion Planning", IEEE Transactions on Power Apparatus and Systems, vol. PAS 100, pp. 4710-4718, Dec. 1981.

[16] R. Billinton and C. Hua, "Assessment of risk-based capacity benefit factors associated with wind energy conversion systems," Power Systems, IEEE Transactions on, vol 13, pp. 1191-1196, 1998

[17] Jorge Valenzuela, Jianhui Wang, “A probabilistic model for assessing the long-term economics of wind energy”, Electric Power Systems Research 81 (2011) 853–861

[18] GAMS user guide available at http://www.gams.com/.

Majlesi Journal of Electrical Engineering

Reliability Indices Utlization in Combined Heat and Power ( CHP ) Optimal Operation

References

References

Volume 8, Issue 4 - Serial Number 4
November 2014
Pages 67-72

Reliability Indices Utlization in Combined Heat and Power ( CHP ) Optimal Operation

References

References

Volume 8, Issue 4 - Serial Number 4November 2014Pages 67-72

Volume 8, Issue 4 - Serial Number 4
November 2014
Pages 67-72