Document Type : Review Article

Authors

University of Tabriz

Abstract

Due to increasing use of renewable energy sources, employing dc/dc converters as interface is proliferated. Among various dc/dc topologies, utilizing multi-input converters due to higher reliability and flexibility is more widespread. This paper evaluates the reliability of the multi-input dc/dc converter, besides carrying out cost calculation to achieve the cost-effective and reliable converter. Furthermore, diagrams of various reliability factors versus the converter’s branches are demonstrated based on mathematical equations and simulation values for both of the parallel and standby redundant modes in order to reach an optimal number of branches in each mode. The results show that the optimal number of branches in terms of reliability or cost factor is different and can vary based on some parameters like output power or component’s type.

Keywords

[1] Tao H, Kotsopoulos A, Duarte J L, Hendrix M A M., “ Family of multiport bidirectional DC–DC converters, ” In: IEE Proc.-Electr. Power Appl 2006; 153: 451-458.
[2] Song Y, Wang B., “Survey on Reliability of Power Electronic Systems,” IEEE Trans. Power electron; vol. 28: pp. 591-604, 2013.
[3] Yang S, Bryant A, Mawby P, Xiang D, Ran L, Tavner P., “An Industry-Based Survey of Reliability in Power Electronic Converters,” IEEE Trans. Ind. Application; vol. 47: pp. 1441-1451, 2011.
[4] Behjati H, Davoudi A., “Reliability Analysis Framework for Structural Redundancy in Power Semiconductors,” IEEE Trans. Ind. Electron; vol. 60, pp. 4376-4386, 2013.
[5] Wang H, Blaabjerg F, “Reliability of Capacitors for DC-Link Applications in Power Electronic
Converters – An Overview,” IEEE Trans. Ind. Appl; vol. 50, pp. 3569-3578, 2014.
[6] Richardeau F, Pham T T L., “Reliability Calculation of Multilevel Converters: Theory and Applications,” IEEE Trans. Ind. Electron; vol. 60, pp. 4225-4233, 2013.
[7] Nozadian M H B, Zarbil M SH, Abapour M., “The Effect of Series and Shunt Redundancy on Power
Semiconductor Reliability,” Journal Power Electron; vol. 16, pp. 1426-1437, 2016.
[8] Kjaer S B, Pedersen J K, Blaabjerg F., “A review of single-phase grid-connected inverters for
photovoltaic modules,” IEEE Trans. Ind. Appl; vol. 41, pp. 1292–1306, 2005.
[9] Khwan-on S, Lillo L de, Empringham L, Wheeler P., “Fault-tolerant matrix converter motor drives with
fault detection of open switch faults,” IEEE Trans. Ind. Electron; vol. 59, pp. 257–268, 2012.
[10] M Farhadi, M Abapour, B Mohammadi-Ivatloo, " Reliability analysis of component-level redundant
topologies for solid-state fault current limiter", International Journal of Electronics 105 (4), 541-558,
2018
[11] Aghdam F H, Abapour M., “Reliability and Cost Analysis of Multistage Boost Converters
Connected to PV Panels,” IEEE Journal Photov;vol. 6, pp. 981–989, 2016.
[12] Lezana P, Pou J, Meynard T, Rodriguez J, Ceballos S,Richardeau F., “Survey on fault operation on
multilevel inverters,” IEEE Trans. Ind. Electron; vol. 57, pp. 2207–2218, 2010.
[13] Villani M, Tursini M, Fabri G, Castellini L., “High reliability permanent magnet brushless motor
drive for aircraft application,” IEEE Trans. Ind. Electron, vol. 59, pp. 2073–2081, 2012.
[14] Khosroshahi A, Abapour M, Sabahi M., “Reliability Evaluation of Conventional and Interleaved DCDC
Boost Converters,” IEEE Trans. Power Electron, vol. 30, pp. 5821–5828, 2015.
[15] Tohid Rahimi, Mehran Sabahi, Mehdi Abapour, Gevork B Gharehpetian, "Three-Phase Soft Switching-Based
Interleaved Boost Converter with High Reliability", IET Power Electronics 10 (3), 377- 386. 2017
[16] Pham T T L, Richardeau F, Gateau G., “Diagnosis strategies and reconfiguration of a 5-level double boost
PFC with fault-tolerant capability,” In: IEEE International Symposium on Industrial Electronics
(ISIE); June 2011; New York, NY, USA:. pp. 1857–1862.
[17] Ceballos S, Pou J, Zaragoza J, Robles E, Villate J L, Martin J L., “Fault-tolerant neutral-point-clamped
converter solutions based on including a fourth resonant leg,” IEEE Trans. Ind. Electron; vol. 58, pp.
2293–2303, 2011.
[18] Pham T T L, Richardeau F, Gateau G., “Fault diagnosis and PDPWM reconfiguration of a 5-level
double-boost PFC with fault-tolerant capability,” In: Conference on IEEE Industrial Electronics
Society. (IECON), Nov. 2010, New York, NY, USA: IEEE. pp. 2839–2844.
[19] Ristow A, Begovic M, Pregelj A, Rohatgi A., “Development of a methodology for improving
photovoltaic inverter reliability,” IEEE Trans. Ind. Electron; vol. 55, pp. 2581–2592, 2008.
[20] HK Jahan, M Naseri, MM Haji-Esmaeili, M Abapour, K Zare, "Low component merged cells cascaded transformer
multilevel inverter featuring an enhanced reliability", IET Power Electronics 10 (8), 855-862. 2017
[21] M Farhadi, M Abapour, M Sabahi, "Failure analysis and reliability evaluation of modulation techniques
for neutral point clamped inverters—A usage model approach", Engineering Failure Analysis 71, 90-104, 2017.
[22] Denson, W., “Handbook of 217PlusTM Reliability Prediction Models,” Utica, NY, USA: RIAC, 2006.
[23] Yu X, Khambadkone A M., “Reliability Analysis and Cost Optimization of Parallel-Inverter
system,” IEEE Trans. Ind. Electron; vol. 59, pp. 3881-3889, 2012