Document Type : Review Article
Authors
Engineering Technical College, Northern Technical University, Mosul, Iraq.
Abstract
This article describes a workflow executed with MATLAB simulation and practical measurements for single phase power transformer. In addition, no-load, short-circuit test and load test are achieved in this work. The test procedures are implemented on a real transformer (terco–type) which has specifications of (1KVA, 220/110V, 50Hz). Finally, the simulation results are appeared proximately similar from the practical results.
Keywords
[1] R. Singuor, P. NeefiPathak& D. S. Babu, "Simulation of Single Phase Transformer with Different Supplies", International Journal of Scientific and Research Publications, India, Vol. 2, Issue 4, ISSN 2250-3153, April 2012.
[2] KV Atransformer, on website:www.tercosweder.com
[3] Andrea Ljubljana, ''Basic Principle and Operation of a Transformer'', University of Ljubljani Fakulteta 20 electrofebniko Trzaka 25, 1000 Ljublijana, Slovenija, March 2018.
[4] G. Aponte, H. Cadavid, J. C. BURGDS, ''A Methodology for Obtaining by Measurements the Transformer Physical-circuital Model Parameters'', Universidad Carios III (3), ISSN 0033-2097, R. 88 NR 9a/2012.
[5] J. Baraniak, K. Pachowicz, A. Nafalski, H. Considine, &Zorica, ''Determination of Parameters of an Equivalent Circuit of a Single-Phase Transformer using a Remote Laboratory'', World Transactions on Engineering and Technology Education, Vol. 14, No. 4, 2016.
[6] R. Majumder, S. Ghosh, R. Mukherjee, ''Transient Analysis of Single Phase Transformers Using State Model'', International Journal of Innovative Research in Science, Engineering and Technology, Vol. 5, Issue 3, March 2016.
)